Home/ Repair guides/ 2005 Honda CRV Radio Replacement

Official iFixit API visual reference

2005 Honda CRV Radio Replacement

This guide is meant to demonstrate how to...

iFixit Library 2005 Honda CRV Moderate 15 - 20 minutes Guide 130663

Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

This guide is meant to demonstrate how to properly remove and replace the factory default radio on the 2005 Honda CRV. Though Honda vehicles are known for their high durability, older components such as the radio may malfunction over time, requiring replacement. Luckily, the radio panel is easily accessible, allowing for easy removal and replacement of the radio.

Step 1

Repair step

⌕

In the middle of the dashboard, locate the radio panel along with the shroud cover.

Step 2

Repair step

⌕

TOOL USED ON THIS STEP Phillips #2 Screwdriver Referenced by the iFixit guide

View item

Remove the two 10mm screws using a Phillips #2 screwdriver underneath the radio shroud in order to remove the radio shroud from the dashboard.

Step 3

Repair step

⌕

Wiggle and pull the dashboard shroud until it comes free from the dashboard.
Even when loosened, the shroud may be difficult to pull off and remove. Do not be afraid to use force to remove the panel from the dashboard.

Step 4

Repair step

⌕

With the dashboard shroud removed, the power chord for the passenger airbag light will be clearly visible with a green connector. Push down on the disconnect tab and remove the chord from the shroud.
Use caution when removing the passenger light cord as excessive force may cause damage.

Step 5

Repair step

⌕

TOOL USED ON THIS STEP Phillips #2 Screwdriver Referenced by the iFixit guide

View item

With all 4 screw mounting points for the radio unit visible, unscrew each 12mm screw using a Phillips #2 screwdriver.

Step 6

Repair step

⌕

TOOL USED ON THIS STEP Phillips #2 Screwdriver Referenced by the iFixit guide

View item

With all mounting screws removed, pull out the radio unit from the dashboard, revealing 3 cables connected to the back of the unit.

Step 7

Repair step

⌕

With all cables visible, locate the antenna cable on the far right and detach it from the radio box

Step 8

Repair step

⌕

Remove both the white steering wheel control cable and the blue power connector cable by pushing down on the removal tabs.
Use caution to avoid excessively stressing exposed cables during removal, making sure to exert force only on the plastic removal tabs.

Step 9

Repair step

⌕

With all cables removed from the radio unit, fully remove the radio from the dashboard.