Home/ Repair guides/ 2000 Chevrolet Tahoe Oil Replacement

Official iFixit API visual reference

2000 Chevrolet Tahoe Oil Replacement

This guide will teach you how to change oil on...

iFixit Library 2000 Chevrolet Tahoe Moderate 25 minutes Guide 132779

Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

This guide will teach you how to change oil on a Chevrolet vehicle. It is important to change oil in a vehicle to avoid damage to the engine. It is also important to regulate the appropriate amount of oil. Check the oil gauge a few times to make sure there is enough oil. It is also important to lubricate the new oil filter before putting it in. Do this by dipping your finger in oil, and then run it over the top of the filter. This will make sure the filter is properly lubricated.

Step 1

Repair step

⌕

Use a jack to raise the vehicle.

Step 2

Repair step

⌕

Locate the oil filter and oil drain plug on the bottom of the vehicle. Place the drain pan underneath them.

Step 3

Repair step

⌕

Use the wrench to unscrew the oil drain plug. Let the oil drain all the way out. Once the oil has emptied, screw the drain plug back in.

Step 4

Repair step

⌕

Using the oil filter cap, unscrew the oil filter. Again, let the oil drain to the drain pan.

Step 5

Repair step

⌕

Receive the new oil filter. Lubricate the top with a small bit of oil. Using the oil cap, screw in the new oil filter.

Step 6

Repair step

⌕

Find the oil port under the hood, near the engine. Place the funnel in the port. Pour in the proper amount of oil needed (check vehicle's owner manual).

Step 7

Repair step

⌕

Using the dipstick check the oil level. It should be near the top end of the holes on the dipstick. Continue checking the oil level, and add more oil if needed. Once filled, fasten the oil port cap back on.