Home/ Repair guides/ DJI Mini 2 Drone Body Replacement

Official iFixit API visual reference

DJI Mini 2 Drone Body Replacement

We are defining the DJI Mini 2 drone body as...

DJI DJI Mini 2 Moderate 15 - 20 minutes Guide 149681

Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

We are defining the DJI Mini 2 drone body as the top and bottom plastic panels of the drone. These panels are the blockaded between the insides of the drone and the outside world. The drone body stores the inner electronic parts of the drone like the GPS, the Main Board, and the wires the drone uses. Damage to the drone body can cause the drone to be unstable in flight. If the body of the drone is damaged they will need to be replaced.

Step 1

Repair step

⌕

Face the DJI Mini 2 away from you so that you are looking at the charging ports.
Use your finger to open up the back panel.

Step 2

Repair step

⌕

Pinch the locking mechanism on the battery to release the lock.
Pull the battery straight out of the compartment.

Step 3

Repair step

⌕

Unfold the wings of the drone.
Place the drone upside down on a flat surface.
There should be stickers on the device telling you how to unfold the propeller arms.

Step 4

Repair step

⌕

Remove the four 5 mm J000 screws near each propeller arm.

Step 5

Repair step

⌕

Flip the drone back over.
Use a combination of the opening tool and your fingers to pry open the top panel of the drone along the seams.

Step 6

Repair step

⌕

Remove the two 5 mm J000 screws located in the battery hatch and near the ports on the back of the drone.

Step 7

Repair step

⌕

Flip the drone over again.
Pry off the bottom panel of the drone using the opening tools and your fingers.