Home/ Repair guides/ DJI Mini 2 Main Board Replacement

Official iFixit API visual reference

DJI Mini 2 Main Board Replacement

This guide will show you how to successfully...

DJI DJI Mini 2 Moderate 30 minutes - 1 hour Guide 149748

Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

This guide will show you how to successfully replace the main board inside the DJI Mini 2 drone. The main board in the DJI Mini 2 helps the drone tell the other parts of the drone what to do and connects the controller and phone connected to the drone. If the main board is damaged the drone will not function or connect to the controller and phone the user wants to connect to. For more information on what may be causing your issue, check out the Troubleshooting page for this device. This guide requires the use of ESD-safe tools to avoid damaging the motherboard or other sensitive components. After replacing the motherboard, you will need to calibrate your DJI Mini 2 drone. Some calibration processes can be done with the DJI Fly mobile app, but for some processes, like gimbal calibration, you will need to use additional software. How to calibrate the gimbal watch this video tutorial https://youtu.be/mu03HWXplM4

Step 1

Repair step

⌕

Face the DJI Mini 2 away from you so that you are looking at the charging ports.
Use your finger to open up the back panel.

Step 2

Repair step

⌕

Pinch the locking mechanism on the battery to release the lock.
Pull the battery straight out of the compartment.

Step 3

Repair step

⌕

TOOL USED ON THIS STEP ESD Safe Blunt Nose Tweezers Referenced by the iFixit guide

View item

Unfold the wings of the drone.
Place the drone upside down on a flat surface.
There should be stickers on the device telling you how to unfold the propeller arms.

Step 4

Repair step

⌕

Remove the four 5 mm J000 screws near each propeller arm.

Step 5

Repair step

⌕

Flip the drone back over.
Use a combination of the opening tool and your fingers to pry open the top panel of the drone along the seams.

Step 6

Repair step

⌕

Remove the two 5 mm J000 screws located in the battery hatch and near the ports on the back of the drone.

Step 7

Repair step

⌕

Flip the drone over again.
Pry off the bottom panel of the drone using the opening tools and your fingers.

Step 8

Repair step

⌕

Remove the three 3mm J000 screws on the black plate.

Step 9

Repair step

⌕

Use your fingers to pull the black plate off to reveal main board.

Step 10

Repair step

⌕

TOOL USED ON THIS STEP ESD Safe Blunt Nose Tweezers Referenced by the iFixit guide

View item

Try to avoid disturbing the blue thermal paste covering two of the large board components. If the paste is disturbed or splotchy in places it may need to be removed and reapplied. For more information refer to the How to Apply Thermal Paste guide.
Using ESD Safe Tweezers Blunt Nose, remove the 5 cables attached to the main board.

Step 11

Repair step

⌕

TOOL USED ON THIS STEP ESD Safe Blunt Nose Tweezers Referenced by the iFixit guide

View item

Use the ESD Safe Tweezers Blunt Nose and your fingers to pull off the main board from the drone carriage.