FIXONIC
SellSavedMy Fixonic
Official iFixit API visual reference

2013 Nissan Altima Interior Door Handle Replacement

This guide is to help demonstrate how to...

iFixit Library 2008-2013 Nissan Altima Moderate 45 minutes Guide 153975
Open the authorised source
Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

This guide is to help demonstrate how to properly replace a 2013 Altima interior door handle. The door handle is important because it allows you easy access to get in and out of your vehicle. With this problem, you will have to find alternatives to get out of your car or worse, overpay a company for a $20 fix. You will only need a flathead screwdriver, a 10 mm socket and wrench, and a new handle.

Step 1

Repair step

  • Use an opening tool or spudger to gently pry open the cover behind the door handle.
  • Use a 10 mm socket to remove the bolt under the handle cap.
Step 2

Repair step

  • Use an opening tool or spudger to pry the window and door lock assembly up and free from the frame.
  • Use a 10 mm socket to remove the single bolt underneath the control assembly.
Step 3

Repair step

  • There is another screw located underneath the long arm panel (to the left of the door handle), unscrew it.
Step 4

Repair step

  • Unhook the cables from the window control panel to take off the door.
Step 5

Repair step

  • Unscrew the three silver screws directly behind the door handle (Top, left, right).
Step 6

Repair step

  • Unhook the two wires that hook into the unlock/lock mechanisms.
Step 7

Repair step

  • Remove the old door handle.
Step 8

Repair step

  • Place and screw the new handle into place.
Step 9

Repair step

  • Hook the lock/unlock wires back into the door handle. (Handle will not work unless this step is complete.
Step 10

Repair step

  • Plug in the window control panel and place the panel back in its respectful place.
  • The door panel clips should goes into the holes and snap in when in place.
Step 11

Repair step

  • Insert the screw beneath the control panel and the screw to the right of the lock/unlock button.
Step 12

Repair step

  • Next, place both the door arm and window control panel in their place. The arm should snap in while the control panel sits flush in place.
Step 13

Repair step

  • Lastly, place the screw back in its respective place and tighten it with the rachet.
Step 14

Repair step

  • Finishing result: The older interior handle is in my hand, while the new interior handle is in place.