FIXONIC
SellSavedMy Fixonic
Official iFixit API visual reference

2006-2011 Honda Civic Dome Light Replacement

If your 2008 Honda Civic does not have a...

iFixit Library 2006-2011 Honda Civic Easy 15 - 30 minutes Guide 154861
Open the authorised source
Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

If your 2008 Honda Civic does not have a functioning dome light or its light is flickering, use this guide to replace the dome light. Before using this guide inspect the dome light. There are multiple reasons why the dome light may not be functioning. Some of these reasons include the bulb is loose, the bulb is burned out, a wiring issue, or a weak battery. Before replacing the bulb, try disconnecting and then reconnecting the car battery to see if the dome light functions again. If the dome light is still not functioning, use this guide to replace the dome light bulb. Before beginning, make sure to disconnect the car battery to avoid a short circuit. Only reconnect the battery following step 7. Avoid touching the bulb with your bare hands as the oils from your hands can cause the bulb to degrade faster or shatter.

Step 1

Repair step

  • Before replacing the dome light and to avoid a short circuit, disconnect the car battery first.
  • Open the hood of your car by pressing the front latch and lift the hood.
  • Carefully attach the hood strut, (located towards the left of your car's engine), into the slot to hold the weight of the hood.
  • Disconnect the positive terminal of the battery in order to avoid short circuits.
Step 2

Repair step

  • Use a spudger and insert it into the space between the dome light cover and edge.
  • Gently pry the cover off but be careful that you don't break any of the clips attaching the cover to the assembly.
Step 3

Repair step

  • Evaluate if the bulb is just loose or if it has burned out and needs to be replaced.
  • In this case, you can see that the bulb has turned black from the inside, indicating it has shorted out. This bulb needs to be replaced.
Step 4

Repair step

  • Use the spudger to detach the bulb from one end of the socket.
  • Pull the bulb out of the socket with the end that is loose.
Step 5

Repair step

  • Align the new bulb with the socket and push it back into place.
  • Ensure the bulb is connected to each end of the socket or it will not function.
Step 6

Repair step

  • Before attaching the cover of the dome light, reconnect the car battery carefully and test the light to make sure it works.
  • Align the tabs on the dome light cover with the holes in the assembly and push the cover back into place.
Step 7

Repair step

  • You should now have a functioning dome light.