Home/ Repair guides/ 2014 Buick Encore Air Intake Filter Replacement

Official iFixit API visual reference

2014 Buick Encore Air Intake Filter Replacement

This guide demonstrates how to replace an Air...

iFixit Library Fast Fix Easy 5 - 10 minutes Guide 158320

Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

This guide demonstrates how to replace an Air Intake for 2014 Buick Encore. An air filter of the car is used to catch dirt or debris to have a clean air flow to the engine. A clean filter increases the lifespan and reliability of an engine. Replacing an air filter in the air intake regularly is very important to prevent inefficiency and maintain the car's performance. A clean air filter also provides for better fuel economy. The part used to replace the air filter is: STP SA11501.

Step 1

Repair step

⌕

Make sure that the vehicle is turned off before proceeding.
Pull the hood release latch under the steering wheel on driver's side.

Step 2

Repair step

⌕

Push the hood latch with your thumb of your right hand.
Lift the hood with your left hand to open the hood.

Step 3

Repair step

⌕

Place the hood prop to the prop hole to secure the hood from falling.

Step 4

Repair step

⌕

Locate the air filter.

Step 5

Repair step

⌕

TOOL USED ON THIS STEP Phillips #2 Screwdriver Referenced by the iFixit guide

View item

Remove the two 5 mm screws from the air filter cover with a Phillips #2 Screwdriver.

Step 6

Repair step

⌕

Pull the air filter cover off.

Step 7

Repair step

⌕

Remove the old air filter.

Step 8

Repair step

⌕

Place the new air filter in the filter box.

Step 9

Repair step

⌕

Place the cover back to original place.
Make sure the hinges on the right side secure the cover.

Step 10

Repair step

⌕

TOOL USED ON THIS STEP Phillips #2 Screwdriver Referenced by the iFixit guide

View item

Insert the two 5 mm screws, and tighten them with a Phillips #2 Screwdriver.

Step 11

Repair step

⌕

Remove the hood prop from the hole.
Secure the hood prop with the hood prop clip.
Close the hood.