FIXONICBefore you begin
This guide demonstrates how to remove the earpiece speaker assembly in your iPhone 15.
Official iFixit API visual reference
Open the authorised source
iPhone 15 Earpiece Speaker Removal
This guide demonstrates how to remove the...
Apple iPhone 15
Moderate
No estimate
Guide 165720
Licensed iFixit integration
This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.
Prepare your phone for disassembly
Tape over any cracks
Remove the pentalobe screws
Mark your opening picks
Heat the bottom edge
- Use a hair dryer or heat gun to heat the bottom edge of the back glass until it's hot to the touch.
Insert an opening pick
- Apply a suction handle to the bottom edge of the back glass.
- Pull up on the handle with a strong, steady force to create a gap between the back glass and the frame.
- Insert the tip of an opening pick into the gap.
Back glass information
- There's a delicate cable connecting the back glass to the phone, right next to the volume down button. Don't insert your pick here to avoid slicing the cable.
- There are multiple spring contacts around the perimeter of the phone. Be extra careful not to insert your pick deeper than suggested in each step to avoid bending these contacts.
Separate the bottom edge adhesive
- Slide your pick back and forth along the bottom edge to separate the adhesive.
- Leave your pick inserted in the bottom right corner to prevent the adhesive from re-sealing.
Heat the right edge
- Heat the right edge of the back glass until it's hot to the touch.
Separate the bottom right corner adhesive
- Rotate your pick around the bottom right corner and slide it to the volume down button or until you feel a hard stop at a large clip securing the back glass.
- Leave this pick inserted to prevent the adhesive from resealing.
Heat the left edge
- Heat the left edge of the back glass until it's hot to the touch.
Separate the left edge adhesive
- Insert a second opening pick at the bottom edge.
- Rotate the second pick around the bottom left corner.
- Slide this pick up to the top left corner to separate the adhesive.
- Leave this pick inserted to prevent the adhesive from resealing.
Heat the top edge
- Heat the top edge of the back glass until it's hot to the touch.
Separate the top edge adhesive
- Rotate your second opening pick around the top left corner and slide it to the top right corner to separate the adhesive.
- Leave this pick in place to prevent the adhesive from resealing.
Heat the top right corner
- Heat the top right corner of the back glass until it's hot to the touch.
Separate the top right corner adhesive
Swing open the back glass
Unfasten the lower connector cover
Remove the lower connector cover
Disconnect the battery
- Hold the back glass upright with one hand and rotate it just enough to reveal the battery press connector just below the volume buttons.
- Use the tip of an opening pick to pry up and disconnect the battery press connector from the logic board.
Disconnect the earpiece speaker
Unfasten the earpiece speaker
- Use a Phillips #000 driver to remove the five screws securing the earpiece speaker:
- Two 1.1 mm‑long screws
- Three 1.6 mm‑long screws
