Home/ Repair guides/ 2006-2013 Toyota Corolla Turn Signal Bulb Repla…

Official iFixit API visual reference

2006-2013 Toyota Corolla Turn Signal Bulb Replacement

Is your signal light not working, and in need...

iFixit Library 2006-2013 Toyota Corolla Moderate 10 - 15 minutes Guide 167388

Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

Is your signal light not working, and in need of replacement? Whether it's due to the weather, A burnt signal light, or a blown fuse. This guide of 9 easy-to-follow steps will help you locate and replace your signal light. Please Note: This guide will only work if it's a signal bulb issue and not a wiring issue.

Step 1

Repair step

⌕

Pull the hood release lever towards yourself until the hood pops.
Open and move the bonnet lever towards the left to completely release the hood.

Step 2

Repair step

⌕

Lift the prop and place it inside bonnet hole to keep the hood open.
The hood prop will be located towards the front of the engine.

Step 3

Repair step

⌕

Turn your wheel to the appropriate side to locate the signal light.
For the left signal light, you would turn your wheel inwards to the right. While for the right side turn your wheel inwards by turning left.

Step 4

Repair step

⌕

Pry off the clip under the wheel well using a flathead screwdriver.
Remove the lining by pulling it straight back.
Some cars are different and may need different tools. For example, some have nuts holding the liner so you'll need a wrench.

Step 5

Repair step

⌕

Twist the signal housing counter-clockwise until it releases.

Step 6

Repair step

⌕

With one hand grab the socket and with the other pull the bulb straight out of the socket.

Step 7

Repair step

⌕

Insert the new bulb into the empty socket place the signal light back into the housing and twist it clockwise to the original position.

Step 8

Repair step

⌕

Make sure your signal works properly by turning it on.