Home/ Repair guides/ 2013 Lexus IS250 Front Dome Light Replacement

Official iFixit API visual reference

2013 Lexus IS250 Front Dome Light Replacement

Maintaining and replacing components can be a...

iFixit Library Lexus IS Moderate 30 - 40 minutes Guide 167599

Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

Maintaining and replacing components can be a cost-effective endeavor. If you need to replace a front headlight dome on a 2013 Lexus is250, this manageable task can be done with a few steps and a bit of patience. This guide will walk you through a step-by-step process to ensure the replacement goes quickly. Before you get started, ensure you have the proper tools and the replacement ready.

Step 1

Repair step

⌕

Open the glasses compartment located near the front dome light. This is usually a straightforward latch or button release.

Step 2

Repair step

⌕

Locate two housings inisde the compartment and gently pry them open using a flathead screwdriver. Take care not to damage the surrounding plastic.

Step 3

Repair step

⌕

Utilize a star screwdriver to remove the screws holding the front dome light in place. Ensure a steady hand to prevent any accidental dropping of screws.

Step 4

Repair step

⌕

With both hands wiggle both sides of the dome. Apply a bit of force at the top to release it from its position. Be cautious to not break the plastic clips securing it.

Step 5

Repair step

⌕

Inside, youll find two bulbs on both ends. Twist them to unlock and carefully remove.

Step 6

Repair step

⌕

Carefully remove bulb. Recommended to use gloves as it can be difficult to get a grip.

Step 7

Repair step

⌕

Replace these bulbs with LED alternatives, inserting them and securing by twisting.

Step 8

Repair step

⌕

Confirm that the bulbs are functioning by checking if the lights turn on. If not double check the alignment of the bulbs to ensure proper contact.
Carefully place the dome back into its original position. Ensure it aligns correctly with the plastic tips. Apply gentle pressure until it clicks back into place.