PlayStation Portal L1 and R1 Bumpers Replacement

This guide shows how to remove and replace the...

Sony PlayStation Portal Easy 5 minutes Guide 171172

Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

This guide shows how to remove and replace the L1 and R1 bumpers (or shoulder buttons) on your PlayStation Portal. If your bumpers feel sticky, follow this guide to pop them off and clean them.

Step 1

Power off your PlayStation Portal

⌕

TOOL USED ON THIS STEP Spudger Referenced by the iFixit guide

View item

Before you begin repairs, power off your PlayStation Portal and unplug any cables.

Step 2

Pry up the L1 bumper

⌕

TOOL USED ON THIS STEP Spudger Referenced by the iFixit guide

View item

Both bumpers are held in place with clips.
Rest a finger over the L1 bumper to prevent it from flying off when you pry.
Insert the flat end of a spudger between the top edge of the bumper and the white shell.
Pry up to unclip the bumper.
Slide the spudger along the seam to release any remaining clips.

Step 3

Repair step

⌕

Remove the L1 bumper.

Step 4

Pry up the R1 bumper

⌕

TOOL USED ON THIS STEP Spudger Referenced by the iFixit guide

View item

Repeat the procedure to pry up and remove the R1 bumper.

Step 5

Reassembly information

⌕

To install a bumper during reassembly:
Align the bumper into its slot.
Use a finger to press the bumper down firmly until it clicks into place.