FIXONIC
SellSavedMy Fixonic
Official iFixit API visual reference

2010-2015 Hyundai Elantra Head Lights Replacement

Replacing a headlight on a 2015 Hyundai Elantra...

iFixit Library 2010-2015 Hyundai Elantra Moderate 30 - 45 minutes Guide 178529
Open the authorised source
Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

Replacing a headlight on a 2015 Hyundai Elantra is straightforward and requires minimal tools. A Phillips screwdriver and a 12 mm wrench. By following these steps, you’ll restore optimal visibility for safe nighttime driving. The headlight assembly can be accessed from under the hood, and each step will guide you in safely disconnecting and replacing the bulb. Before you begin, here are some important details: Bulb Type: The 2015 Hyundai Elantra uses an H11 bulb. Double-check to ensure compatibility with your specific model.Caution: Avoid touching the glass of the new bulb, as oil from your hands can cause it to burn out prematurely.Note: Make sure the vehicle is parked on a flat, stable surface with the engine turned off and the parking brake engaged.Hazards: If working around electrical components, be mindful of the power cable. Disconnecting the car battery can help reduce the risk of accidental shorts or electrical hazards, though it is not required for this specific repair. Now that you're prepared, you can proceed through each step to complete the headlight replacement with confidence.

Step 1

Repair step

  • Before you begin, disconnect the car battery.
  • Locate the hood release lever inside the cabin near the driver’s side footwell. Pull the lever to release the hood.
Step 2

Repair step

  • Slide the hood latch above the Hyundai emblem at the front of the vehicle to unlock the hood.
  • Lift the hood and secure it with the hood prop.
Step 3

Repair step

  • Use a 12 mm wrench to remove the single 12 mm bolt.
  • Use a Phillips #2 to remove two 15.0 mm screws securing the headlight assembly.
Step 4

Repair step

  • Disconnect the power cable from the back of the headlight.
  • Apply gentle pressure to pull the headlight assembly out from the chassis.
Step 5

Repair step

  • Position the headlight assembly securely.
  • Remove the cover protecting the light bulb.
  • Twist the bulb counterclockwise to release it from the socket.
Step 6

Repair step

  • Disconnect the old bulb from the power connector, avoiding contact with the bulb glass.
  • Insert the new bulb into the connector, ensuring a secure fit before placing it back into the headlight assembly.
Step 7

Repair step

  • Align the headlight assembly with the chassis and reconnect the power connector.
  • Reinsert and tighten the screws and bolt to secure the headlight in place.