iPhone 16 Pro Max Charge Port Removal

Removal steps for the charge port in the iPhone...

Apple iPhone 16 Pro Max Moderate 1 - 3 hours Guide 181193

Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

Removal steps for the charge port in the iPhone 16 Pro Max.

Step 1

Remove the charge port

⌕

TOOL USED ON THIS STEP P2 Pentalobe Screwdriver iPhone Referenced by the iFixit guide

View item

TOOL USED ON THIS STEP Phillips #000 Screwdriver Referenced by the iFixit guide

View item

Use a Phillips screwdriver to remove the two 3.3 mm‑long screws securing the charge port to the frame.
These screws are tight and can be difficult to reach. Angle your screwdriver at as shallow of an angle as you can, but be careful not to press against the battery.

Step 2

Repair step

⌕

TOOL USED ON THIS STEP Spudger Referenced by the iFixit guide

View item

The charge port has an adhesive gasket that seals it against the bottom of the frame. It's also tucked behind two prongs, which prevents you from pulling the port away from the frame.
Insert the point of a spudger under one side of the charge port.
Pry up gently to separate the gasket and lift the port up.
Repeat on the other side to fully loosen the port.

Step 3

Repair step

⌕

TOOL USED ON THIS STEP P2 Pentalobe Screwdriver iPhone Referenced by the iFixit guide

View item

TOOL USED ON THIS STEP Phillips #000 Screwdriver Referenced by the iFixit guide

View item

Remove the charge port.
The two screw posts underneath the charge port have grounding clips on them. If the clips fell off, be sure to place them back onto their posts. The clips should face towards the bottom of the iPhone.