FIXONICBefore you begin
Reassembly steps to install the charging port in the iPhone 16 Pro.
Official iFixit API visual reference
Open the authorised source
iPhone 16 Pro Charging Port Installation
Reassembly steps to install the charging port...
Apple iPhone 16 Pro
Moderate
No estimate
Guide 181234
Licensed iFixit integration
This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.
Reassembly tips
- Grounding clips clip on top of both screw posts under the charging port. Make sure they're still clipped in place. The clips should face towards the bottom edge of the iPhone.
- Make sure the two black prongs on either side of the charging port are standing straight up. If they were bent when you removed the port, use the point of a spudger to carefully straighten them.
- If you have replacement adhesive, use tweezers to remove all of the original adhesive securing the port to the frame before installing it.
Install the charging port
- Slide the charging port in place so its screw posts sit between the black prongs and the bottom of the frame.
- Slide the charging port screw tabs on the cable-side of the port between the screw posts and the screw tabs on the microphone.
Repair step
- Use a P2 pentalobe screwdriver to install the two 7.4 mm‑long screws on either side of the charging port from outside the phone.
- Ensure the two screws are sticking through the holes in the black prongs. This will help align the port with the frame.
Repair step
- Use a tri-point Y000 screwdriver to install the 1.3 mm‑long screw in the bottom-right corner of the charging port to secure it to the frame.
Repair step
- Use a P2 pentalobe screwdriver to remove the two 7.4 mm‑long screws on either side of the charging port from outside the phone.
Repair step
Repair step
- Use a standoff screwdriver to install the 3.6 mm‑long screw securing the charging port and microphone to the frame.