iPhone 16 Plus Rear Cameras Installation

Reassembly steps for the rear cameras in the...

Apple iPhone 16 Plus Moderate No estimate Guide 181351

Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

Reassembly steps for the rear cameras in the iPhone 16 Plus.

Step 1

Install the rear cameras

⌕

TOOL USED ON THIS STEP Phillips #000 Screwdriver Referenced by the iFixit guide

View item

TOOL USED ON THIS STEP Spudger Referenced by the iFixit guide

View item

Align the rear cameras with their screw posts and place them in the frame.
Make sure the lower camera cable is routed in the channel above the battery.

Step 2

Secure the rear cameras

⌕

TOOL USED ON THIS STEP Phillips #000 Screwdriver Referenced by the iFixit guide

View item

Use a Phillips screwdriver to install the three screws securing the rear cameras:
One 2.4 mm‑long screw
One 3.2 mm‑long screw
One 4.7 mm‑long screw

Step 3

Connect the rear cameras

⌕

TOOL USED ON THIS STEP Spudger Referenced by the iFixit guide

View item

Use your finger or a spudger to connect the two rear camera press connectors, located in the bottom left corner of the logic board.

Step 4

Connect the right side buttons

⌕

TOOL USED ON THIS STEP Spudger Referenced by the iFixit guide

View item

Use your finger or a spudger to connect the power/Camera Control button press connector.