Home/ Repair guides/ 2008-2013 Toyota Highlander Sun Visor Replaceme…

Official iFixit API visual reference

2008-2013 Toyota Highlander Sun Visor Replacement

This guide will show you how to properly...

iFixit Library 2008–2013 Toyota Highlander Easy 10 - 20 minutes Guide 197384

Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

This guide will show you how to properly replace the sun visor in a 2008-2013 Toyota Highlander. A sun visor can fail for many reasons, such as broken hinges or a visor that won’t stay up. Repairing a damaged sun visor is important, as a malfunctioning visor can distract the driver or fail to block bright sunlight, creating a safety risk. Before you begin the repair, ensure that the vehicle is parked and the parking brake is engaged. Adjust your seat so you can comfortably sit in an upright position for an extended period of time.

Step 1

Repair step

⌕

If the sun visor is folded up, fold it down.

Step 2

Repair step

⌕

Unclip the sun visor from the inside hook on the ceiling of the passenger side.

Step 3

Repair step

⌕

Move the sun visor to the side in order to allow for easier access to the plastic cover.
If you are replacing the driver side sun visor, move the sun visor to your left; if you are replacing the passenger side sun visor, move the sun visor to your right.

Step 4

Repair step

⌕

Use a trim removal tool or a plastic opening tool to gently pry the plastic cover from the base of the visor.

Step 5

Repair step

⌕

Remove the plastic cover by pulling it back and wiggling it free from the sun visor.
Don't be afraid to use a little force—the cover is made out of a soft plastic, so it won't break easily.

Step 6

Repair step

⌕

TOOL USED ON THIS STEP Phillips #2 Screwdriver Referenced by the iFixit guide

View item

Use a Phillips #2 screwdriver to remove the bottom 2.5 mm screw from the plastic base of the sun visor.

Step 7

Repair step

⌕

TOOL USED ON THIS STEP Phillips #2 Screwdriver Referenced by the iFixit guide

View item

Use the Phillips #2 screwdriver to remove the top 2.5 mm screw.
Support the sun visor with your free hand while removing the second screw to prevent it from falling.

Step 8

Repair step

⌕

Lightly pull down on the plastic base to unplug the sun visor.
Depending on the make of the sun visor, you may need to also press on a tab located underneath the plastic base.
Set the visor aside.

Step 9

Repair step

⌕

Press down on the front clip to release the visor bracket cover from the mounting bracket.

Step 10

Repair step

⌕

Slide the C-shaped cover off the bracket through the open end.
You may need to pull it if it doesn't slide off easily.

Step 11

Repair step

⌕

TOOL USED ON THIS STEP Phillips #2 Screwdriver Referenced by the iFixit guide

View item

Lift the replacement visor to the socket on the sealing, ensuring the plastic base and screw holes are aligned.

Step 12

Repair step

⌕

TOOL USED ON THIS STEP Phillips #2 Screwdriver Referenced by the iFixit guide

View item

Push the sun visor connector into the socket until it sits flush with the ceiling.
Use a Phillips #2 screwdriver to tighten the screws and secure the sun visor connector.
Remember to slide the C-shaped bracket cover over the top of the connector.