FIXONICBefore you begin
This guide shows how to remove the battery from an iPhone 17 Pro.
Official iFixit API visual reference
Open the authorised source
iPhone 17 Pro Battery Removal
This guide shows how to remove the battery from...
Apple iPhone 17 Pro
Moderate
No estimate
Guide 199452
Licensed iFixit integration
This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.
Safety precautions
Cracked glass preparation
- Apply strips of packing tape to the cracked glass until it's completely covered—this will help keep the glass contained and allow the suction cup to stick.
- Make sure there's a single strip of tape (not overlapping) across the bottom edge, big enough for a suction cup to fit on.
Remove the pentalobe screws
Mark your opening picks
Heat the bottom edge
Apply a suction handle
Screen bezel information
- There's a plastic bezel on the underside of the screen that sits on the frame. Insert your pick here, making sure it's completely under the bezel.
- There's a seam between the plastic bezel and the display panel. Don't insert your pick here or you'll separate the two, complicating the repair.
Insert an opening pick
- Pull up on the suction handle with strong, steady force until a gap forms between the screen and frame.
- Insert the tip of an opening pick in the gap you just created.
Screen information
- The screen and ambient light sensor cables are located near the volume and Action buttons.
- There are delicate spring contacts around the perimeter of the phone.
- The underside of the screen has thin, metal clips that go into corresponding slots on the frame.
Separate the bottom edge adhesive
- Slide the opening pick along the bottom edge to separate the adhesive.
- Leave the pick inserted under the bottom right corner to prevent the adhesive from re‑sealing.
Remove the suction handle
Heat the right edge
Separate the right edge adhesive
- Insert a second opening pick under the bottom right corner of the screen.
- Slide the pick up the right edge to separate the adhesive and release the two clips.
- Leave the pick inserted under the top right corner to prevent the adhesive from re‑sealing.
Heat the top edge
Separate the top edge adhesive
- Insert a third opening pick under the top right corner of the screen.
- Slide the pick along the top edge and just barely around the top left corner to separate the adhesive and release the two clips.
- Leave the pick inserted under the top left corner to prevent the adhesive from re‑sealing.
Heat the left edge
Separate the left edge adhesive
- Insert a fourth opening pick under the bottom left corner of the screen.
- Slide the pick up the right edge to separate the adhesive and release the clip, stopping just before the volume up button.
Prop up the screen
Remove the cover screws
- Use a JIS 00 screwdriver to remove the two screws securing the cable covers:
- One 1.4 mm‑long screw for the screen and front sensor cable cover
- One 1.3 mm‑long screw for the battery cover
Remove the covers
Disconnect the battery
Disconnect the screen
- Use the tip of an opening pick or the point of a spudger to pry up and disconnect the screen and ambient light sensor press connectors.
Remove the screen
- Remove the screen.
Remove the battery tray screws
- Use a Torx Plus 4IP screwdriver to remove the screws securing the battery tray:
- One 7.5 mm‑long screw
- One 5.9 mm‑long screw
- One 3.4 mm‑long screw
- One 2.3 mm‑long screw
- Nine 3.7 mm‑long screws
- One 3.7 mm‑long screw
Remove the battery
- Use your finger to lift the top left corner of the battery tray and remove it.