Home/ Repair guides/ 2010 Toyota Corolla Bumper Replacement

Official iFixit API visual reference

2010 Toyota Corolla Bumper Replacement

Front bumper damage is one of the most common...

iFixit Library 2006-2013 Toyota Corolla Moderate 45 minutes Guide 206882

Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

Front bumper damage is one of the most common cosmetic issues on older vehicles like the 2010 Toyota Corolla. The main use of the front bumper is to protect the vehicle's body and internal components and supporting exterior pieces of the car. Driving with a damaged bumper will cause even more damage over time. This guide is to explain how to safely detach your old bumper and reinstall a replacement bumper so that your car is properly secured and restored to its original appearance.

Step 1

Repair step

⌕

Turn off the vehicle, open the hood, and prop it open with the hood prop.

Step 2

Repair step

⌕

Using the power drill, remove the fasteners along the top of the bumper.

Step 3

Repair step

⌕

Remove the clips using your hands.
Remove the socket head cap screws with a ratcheting socket wrench.

Step 4

Repair step

⌕

Using the power drill, remove screws and clips from the wheel well liners and remove the lower bumper fasteners underneath the car on the right side.

Step 5

Repair step

⌕

Using the power drill, remove screws and clips from the wheel well liners and remove the lower bumper fasteners underneath the car on the left side.

Step 6

Repair step

⌕

Carefully pull the bumper cover forward and disconnect the fog light wiring before fully removing the bumper.

Step 7

Repair step

⌕

Align the replacement bumper with the mounting points and reconnect any electrical connections.

Step 8

Repair step

⌕

Using the power drill, reinstall and tighten all four top bumper fasteners and any other clips or socket head cap screws.

Step 9

Repair step

⌕

Using the power drill, reinstall the two lower bumper fasteners and verify the bumper's proper fit and alignment.