Home/ Repair guides/ 2012-2014 Audi A6 Tail Light Replacement

Official iFixit API visual reference

2012-2014 Audi A6 Tail Light Replacement

This guide shows how to remove and replace the...

iFixit Library 2012-2014 Audi A6 Easy 15 minutes Guide 212779

Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

This guide shows how to remove and replace the tail light bulb on a 2012–2014 Audi A6. The process involves removing a small access panel, taking out two T25 screws, and carefully pulling the tail light assembly out. Basic tools are required, and the job can be completed in a few minutes.

Step 1

Repair step

⌕

Open the trunk.
Remove the access cover.
Locate the two T25 Torx screws securing the tail light.

Step 2

Repair step

⌕

Use a T25 Torx bit to loosen the upper screw securing the tail light.
Repeat for the lower screw.
Remove both screws completely and set them aside in a safe place.
Do not drop the screws inside the trunk or body panel. Keep them in a safe place for reinstallation.

Step 3

Repair step

⌕

Grasp the tail light assembly firmly with both hands.
Pull the tail light straight outward from the vehicle to release it from the mounting clips.
Pull the tail light straight out. Do not twist or force it, as this may damage the mounting tabs or wiring.

Step 4

Repair step

⌕

Locate the tail light bulb socket on the back of the assembly.
Grip the socket firmly and rotate it counterclockwise.
Pull the socket straight out to remove it from the housing.

Step 5

Repair step

⌕

Pull the old bulb straight out of the socket.
Insert the new bulb into the socket, aligning it properly.
Press the bulb firmly into place until fully seated.

Step 6

Repair step

⌕

Insert the bulb socket back into the tail light housing.
Rotate the socket clockwise until it locks into place.

Step 7

Repair step

⌕

Align the tail light assembly with the vehicle’s mounting points.
Press the tail light firmly into position until fully seated.
Make sure the tail light is fully seated before tightening screws.
Reinstall the two T25 Torx screws and tighten securely.
Snap the plastic access cover back into place.