FIXONIC
SellSavedMy Fixonic
Official iFixit API visual reference

2006-2011 Honda Civic Bulb Replacement for Rear Turn Signals

This guide is to help you replace a burnt-out...

iFixit Library 2006-2011 Honda Civic Easy 10 - 20 minutes Guide 214794
Open the authorised source
Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

This guide is to help you replace a burnt-out rear turn signal bulb on a 2006-2011 Honda Civic. If your turn signal is out, dim, or improperly installed, this guide will walk you through replacing it in under ten minutes. The bulb type, 7440 amber-colored, is a suggestion; make sure to check your handbook or car's specifications to get the correct one. When handling a new bulb, always wear gloves to avoid transferring oils to the light. Wearing gloves reduces the possibility of the bulb shattering when it heats up. To begin, gather your replacement bulb, gloves, and flathead screwdriver. Make sure the engine is turned off before starting.

Step 1

Repair step

  • For safety, turn off the engine and any car lights.
  • Open the trunk and locate the two black fasteners that hold the fabric cover in place.
Step 2

Repair step

  • Use the flathead screwdriver to turn each fastener counterclockwise.
  • Remove the two components of each fastener from the fabric cover.
Step 3

Repair step

  • Pull out the fabric cover.
  • Find the rear turn signal bulb socket. It is the white colored socket located on top.
Step 4

Repair step

  • Pinch the white plastic connector and pull it away from the socket.
  • Turn the socket 90 degrees counter-clockwise, and pull it out.
Step 5

Repair step

  • Pull the damaged bulb straight out and properly discard it.
  • With gloves, gently push the new bulb directly down into the slot.
Step 6

Repair step

  • Reinsert the socket and turn it 90 degrees clockwise.
  • Reconnect the wiring to the socket.
  • Push the fabric cover back into place, and replace each of the three fasteners. Tighten them clockwise using the flathead screwdriver.
Step 7

Repair step

  • If both rear turn signals are burnt out, repeat this process on the other side.
  • Turn on the car, and test the light. If anything was replaced incorrectly, the turn signal will blink at a quicker rate than normal.