FIXONIC
Repair starts here.Sign inCreate account Live auctionsRepair HubRepair guides
SellSavedMy Fixonic
FIXONICrepair marketplace
Home/ Repair guides/ 2009-2014 Nissan Maxima CVT Fluid Change
Official iFixit API visual reference

2009-2014 Nissan Maxima CVT Fluid Change

Attributed iFixit repair guide for Nissan.

iFixit Library Nissan Easy 45 minutes Guide 25940
Open the authorised source
Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Step 1

Repair step

No step image supplied by iFixit.
  • Drive the car prior to performing the CVT fluid change. The fluid should be warm when it is changed.
  • Park the car on a flat surface. While the car is running, keep your foot on the brakes and move the gear shift through all of gears: P, R, N, D1, D2, D3.
  • Put the car in Park and turn the car off.
Step 2

Repair step

No step image supplied by iFixit.
Flathead 3/32" or 2.5 mm Screwdriver
TOOL USED ON THIS STEP Flathead 3/32" or 2.5 mm Screwdriver Referenced by the iFixit guide
View item
  • Remove the transmission fluid dipstick.
  • Using a flathead screwdriver, push in the black plastic tab of the dipstick and pull it out.
  • Using a clean rag, wipe the fluid off and then reinsert it. However, insert it backwards so that it doesn't lock again.
  • Pull the dipstick out again and verify that the fluid mark is at the second notch at the bottom of the dipstick.
  • Keep the dipstick out of the drain hole.
Step 3

Repair step

No step image supplied by iFixit.
  • Move the drain pan underneath the transmission drain pan.
  • Approximately five quarts of CVT fluid will be drained.
  • Use a 00mm socket to remove the drain bolt.
  • TIP: Use the socket to loosen the bolt and then use your fingers to finish removing the bolt. This will help prevent the fluid from leaking onto the socket wrench.
Step 4

Repair step

No step image supplied by iFixit.
  • Leave the fluid drain for approximately 10-15 minutes.
  • Insert a new crush washer onto the drain bolt.
  • Insert the bolt into the transmission and tighten it with you fingers.
  • Use a torque wrench to tighten the bolt to xx ft/lbs.
Step 5

Repair step

No step image supplied by iFixit.
  • Refill the transmission with CVT fluid. The car typically takes xx quarts of CVT fluid.
  • Insert three quarts of fluid.
  • Insert the dipstick and check the fluid level.
  • Continue to add small amounts of fluid until the dipstick shows that the fluid reaches the second mark from the bottom.
Step 6

Repair step

No step image supplied by iFixit.
  • Reinsert and lock the dipstick.
  • Take the car for a drive. Don't drive too aggressively.