FIXONIC
Repair starts here.Sign inCreate account Live auctionsRepair HubRepair guides
SellSavedMy Fixonic
FIXONICrepair marketplace
Home/ Repair guides/ 1998-2002 Honda Accord Distributor Rotor Replac…
Official iFixit API visual reference

1998-2002 Honda Accord Distributor Rotor Replacement

Use this guide to replace your Honda Accord's...

iFixit Library 1998-2002 Honda Accord Moderate No estimate Guide 3636
Open the authorised source
Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

Use this guide to replace your Honda Accord's distributor rotor. This specific guide was created for a non-VTEC F23A5 engine, but other 4-cylinder Honda engines will be similar enough to follow the same basic steps. You may have to remove the engine cover in later Accord models.

Step 1

Repair step

1998-2002 Honda Accord Distributor Rotor Replacement — repair step ⌕
  • Before disconnecting the spark plug wires, be sure to trace their orientation from the individual cylinders back to the distributor cap.
  • The cylinders are ordered from left to right when viewing the engine from the front of the car, with cylinder #1 being closest to the passenger side of the vehicle.
  • Mark the order of the spark plug wires on the new distributor cap with a silver sharpie marker -- it will make reinstallation much easier.
Step 2

Repair step

1998-2002 Honda Accord Distributor Rotor Replacement — repair step ⌕
  • Disconnect the four spark plug wires from the distributor cap by pulling their connectors straight away from the sockets on the distributor cap.
  • It may be helpful to slightly twist the wires as you pull them.
Step 3

Repair step

1998-2002 Honda Accord Distributor Rotor Replacement — repair step ⌕
  • Use a 1/4" drive, 8 mm deep socket to remove the three hex bolts securing the distributor cap to the engine.
  • The position of the third bolt is not visible in the second picture.
Step 4

Repair step

1998-2002 Honda Accord Distributor Rotor Replacement — repair step ⌕
  • Pull the distributor cap away from the engine and set it aside.
Step 5

Repair step

1998-2002 Honda Accord Distributor Rotor Replacement — repair step ⌕
Phillips #2 Screwdriver
TOOL USED ON THIS STEP Phillips #2 Screwdriver Referenced by the iFixit guide
View item
  • Use a dental pick or a small screwdriver to gently remove the D-shaped o-ring around the distributor cap flange.
  • Install a new o-ring in the seal recess, making sure that it is sitting flush against the flange.
Step 6

Repair step

1998-2002 Honda Accord Distributor Rotor Replacement — repair step ⌕
Phillips #2 Screwdriver
TOOL USED ON THIS STEP Phillips #2 Screwdriver Referenced by the iFixit guide
View item
  • Remove the single #2 Phillips screw securing the distributor rotor to the shaft.
Step 7

Repair step

1998-2002 Honda Accord Distributor Rotor Replacement — repair step ⌕
Phillips #2 Screwdriver
TOOL USED ON THIS STEP Phillips #2 Screwdriver Referenced by the iFixit guide
View item
  • Pull the distributor rotor straight off its shaft, being careful not to rotate the shaft as you remove it.
  • When installing the new distributor rotor, press it onto the shaft with the screw holes aligned axially.