Home/ Repair guides/ 2008 Subaru Impreza Windshield Wiper Arm Adjust…

Official iFixit API visual reference

2008 Subaru Impreza Windshield Wiper Arm Adjustment

Proper visibility when driving is crucial to...

iFixit Library Subaru Moderate 10 minutes Guide 61593

Licensed iFixit integration

This attributed iFixit guide is displayed through Fixonic's recorded commercial API permission. iFixit remains the independent source and author of the procedure.

Guide overview

Before you begin

Proper visibility when driving is crucial to safe transportation. In rain and snow, suitable windshield wipers will help ensure clear visibility. Use this guide to realign the front windshield wiper arm on a 2008 Subaru Impreza. In a few easy steps, this guide will get you back on the road to safer driving.

Step 1

Repair step

⌕

To begin, pop open your hood for best access.

Step 2

Repair step

⌕

There will be a rectangular bolt cover on the end of the wiper arm.
To remove this cover, grab each side with your fingers and pull upward.
It may help to wedge your fingernails underneath the cover piece.

Step 3

Repair step

⌕

After removing the bolt cover, you will find the bolt that holds the wiper arm onto the vehicle.

Step 4

Repair step

⌕

TOOL USED ON THIS STEP 14 mm socket Referenced by the iFixit guide

View item

Loosen the bolt with the socket wrench just enough to be able to move the arm up and down the windshield.
To loosen with the wrench, place the socket directly on top of the bolt and turn counter clockwise.

Step 5

Repair step

⌕

Adjust the windshield wiper arm such that it is in the proper resting position.

Step 6

Repair step

⌕

There should be approximately 2 inches of space between the bottom of the windshield and the wiper in proper resting position.

Step 7

Repair step

⌕

TOOL USED ON THIS STEP 14 mm socket Referenced by the iFixit guide

View item

Once the arm is in correct position, tighten the same bolt at the bottom of the arm to keep the wiper in place.
To tighten the bolt, place the socket directly on top of the bolt and turn in clockwise position until you are no longer able to turn.

Step 8

Repair step

⌕

Place the bolt cover back over the bolt and push it down into clipped position.

Step 9

Repair step

⌕

Close the hood of the vehicle. Your windshield wiper should now be in the correct position.